General Operating Instructions

To Wax An Object:

1.Attach the Foam Bonnet (53) to the Mounting Disc (51) as previously discussed in this manual.

NOTE: Prior to waxing an object, make sure the surface has been thoroughly cleaned and is free of dust, dirt, oil, grease, etc.

2.Apply about two tablespoons of polishing liquid or wax (not included) evenly on the Foam Bonnet (53). Do not apply the polishing liquid or wax directly to the object’s surface. The amount of polishing liquid or wax needed will vary according to the object’s size. Avoid using too much polishing liquid or

wax. The Foam Bonnet will not absorb as much polishing liquid or wax in subsequent applications.

3.Plug the Power Cord (5) into the nearest 120 volt, grounded, electrical outlet.

4.In order to keep the Power Cord (5) out of the way, hang it over your shoulder.

IMPORTANT: Start and stop the Polisher only while it is held firmly against the surface of the object being waxed.

Failure to do so may result in the Foam Bonnet (53) being thrown from the Mounting Disc (51).

5.Grip the Polisher firmly with both hands.

Then turn the Power Switch (11) to its “ON” position. (See Figure C.)

FIGURE C

DISPLAY

(10)

POWER

SWITCH (11)

– SPEED	+ SPEED
BUTTON (12)	BUTTON (13)

6.Increase the tool’s speed by pressing the + Speed Button (13). Decrease the tool’s speed by pressing the – Speed Button (13). (See Figure C.)

7.The Display (10) will indicate the tool’s speed.

NOTE: When first applying wax to the object, start the tool at its lowest speed to avoid throwing wax off the Foam Bonnet (53). Then increase the speed as needed.

8.Begin applying polishing liquid or wax to the object. Apply the polishing liquid or wax to all flat surfaces with broad sweeping strokes in a figure eight pattern. Apply the polishing liquid or wax evenly over the surface of the object, and add additional polishing liquid or wax as needed.

9.After the polishing liquid or wax has been applied to the object’s surface, turn the Power Switch (11) to its “OFF” position. Then unplug the Power Cord (5).

(See Figure C.)

10.Remove the Foam Bonnet (53) from the Mounting Disc (51). With the Foam Bonnet in your hand, apply the polishing liquid or wax to all hard to reach areas of the object. (See Figures A and B.)

		REV 10b
Page 12	For technical questions, please call 1-800-444-3353.	SKU 66615