Installation Instructions

			Page
IMPORTANT!
Please Read Before Starting			2
1.	GENERAL		3
	1-1.	Tools Required for Installation (not supplied)
	1-2.	Accessories Supplied with Unit
	1-3.	Optional Copper Tubing Kit
	1-4.	Type of Copper Tube and Insulation Material
	1-5.	Field Wiring
	1-6.	Additional Materials Required for Installation
2.	INSTALLATION SITE SELECTION		4
	2-1.	Indoor Unit
	2-2.	Outdoor Unit
3. HOW TO INSTALL THE INDOOR UNIT			6
	3-1.	Remove the Rear Panel from the Unit
	3-2.	Make a Hole
	3-3.	Install the Rear Panel on the Wall
	3-4.	Remove the Grille to Install the Indoor Unit
	3-5.	Shape the Indoor Side Tubing
	3-6.	Wiring Instructions
	3-7.	Recommended Wire Length and Diameter
	3-8.	Wiring Instructions for Inter-unit Connections
	3-9.	Mounting
	3-10.	Drain Hose
4. HOW TO INSTALL THE OUTDOOR UNIT			15
	4-1.	Wiring Instructions for the Outdoor Unit
5.	REFRIGERANT TUBING		16
	5-1.	Use of the Flaring Method
	5-2.	Flaring Procedure with a Flare Tool
	5-3.	Caution before Connecting Tubes Tightly
	5-4.	Connecting Tubing between Indoor and
		Outdoor Units
	5-5.	Insulation of Refrigerant Tubing
	5-6.	Taping the Tubes

Model Combinations

Combine indoor and outdoor units only as listed below.

Indoor Units

Outdoor Units

KHS0951CH0951

KHS1251CH1251

Power Source:

60 Hz, single-phase, 115 V

KHS1852CH1852

Power Source:

60 Hz, single-phase, 230/208 V

5-7. Finishing the Installation
6. AIR PURGING	18

■Air Purging with a Vacuum Pump (for Test Run)

■Basic Function of the Service Valves

■Pump Down

7.REMOTE CONTROL UNIT INSTALLATION

POSITION	22
7-1. Mounting on a Wall

IMPORTANT

Power source for CH0951 and CH1251 is 60 Hz, single-phase 115 V.

	In Canada
SANYO FISHER COMPANY	SANYO Canada Inc.
A DIVISION OF SANYO NORTH AMERICA CORPORATION	300 Applewood Crescent, Concord
21605 Plummer Street	Ontario, L4K 5C7, Canada
85264189615003 © SANYO 2002 Chatsworth, CA 91311 U.S.A.
	W

Sanyo CH0951, CH1251 installation instructions Installation Instructions, Contents