Dremel 1200 manual On/Off Switch, Changing Glue Sticks, Do not attempt to remove the unused por

Pop-Up

Stand

DM 2610933927 11-05.qxd 4/12/06 4:20 PM Page 4

Indicator Lights

On/Off Switch

Squeeze the trigger repeatedly until hot glue begins to flow from the nozzle. NOTE: For your first use, you may need to load up to two full glue sticks before glue begins to flow.

		Trigger
Changing Glue Sticks
Do not attempt to remove the unused por-
tion of the glue stick from your glue gun. If
you need to switch glue stick formulas,
empty the melting chamber by squeezing
the trigger and insert new formula.
Changing Nozzles
!	WARNING	Disconnect the plug
		from the power source
and allow the tool to cool before
attempting to change the nozzle. Such
preventative		safety measures reduce

the risk of accidental burns.

The Dremel Glue Gun comes with two additional tips. The first tip is a fine point tip for laying down very fine lines where a small amount of glue is needed. The sec- ond tip is a spreader tip for laying down a wider strip of glue. To remove the stan- dard nozzle from the glue gun and replace it with a different nozzle, start by removing the silicon safety sleeve. Place a adjustable wrench around the collar of the nozzle and turn the wrench counter-clock- wise until the nozzle is loose. Using your hand, pull the nozzle off the threads. Place the new nozzle on the threads and begin to tighten by hand. Once the tip is

started on the threads, tighten the remain- der with an adjustable wrench until the tip is secured tightly on the glue gun. Place the silicon safety sleeve over the new tip. The glue gun is now ready for use.

Anti-Drip Feature

The Anti-Drip feature is activated by releasing the trigger which will cut off the flow of glue into the channel. A small amount of glue will remain in the tip when the trigger is released and this will need to drain from the tip. To optimize the Anti- Drip feature, release the trigger and allow the small amount of melted glue remaining in the tip to drain onto project surface before setting glue gun on stand. If you would prefer to allow this small amount of melted glue to drain elsewhere, set your glue gun a non-porous surface such as a tile or flat piece of tin. It is recommended that you use this protective surface at all times when working with your glue gun.

When the glue gun is not in use, prop the glue gun on the spring-loaded stand. If the spring loaded stand is not used, the tool will lay on it’s side. Do not lay the glue gun on its side. To open stand, press button on side of glue gun. To retract stand, careful- ly fold in to original position.

Pop-Up Stand

To stabilize the glue gun on a flat surface use the pop-up stand. To release the pop- up stand, press the button on either side of the glue gun. To retract the stand, push back into the locked position with your forefinger.

Stand release button

Headlight

The headlight will remain on when the glue gun is in one of the one positions (Lo/Hi). To turn the light off, slide the glue gun switch to the off position.

4