Schumacher 6/2 Amp Dual Rate Battery Charger - User Guide and Controls

Page 3

BATTERY CHARGER CONTROLS

The SE-82-6 and SE-3002 battery charger has a selector switch and an ammeter for reading AMP's. FIGURE 3 shows the charger controls.

6/2 AMP DUAL RATE BATTERY CHARGER

INPUT: 120V AC 60HZ 1.3 AMP

6 and 12 Volt Batteries

6 VOLT

12 VOLT

12 VOLT

 

 

OUTPUT: 6/2 AMP AT 12V DC, 6 AMP AT 6V DC

 

6 AMP

2 AMP

6 AMP

 

 

 

READ INSTRUCTION MANUAL AND WARNING ON BACK

Model SE-82-6

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

NOTE: Model SE-3002 meter is similar but, presented in a horizontal format.

 

 

 

 

Figure 3

CHARGE RATE AND VOLTAGE SWITCH SETTINGS

For 12 volt batteries either 2 or 6 amp charge rate may be se- lected. For 6 volt batteries, only the 6 amp rate is available. You may use either the 2 or 6 amp charge rate on large batteries. For batteries rated 28 ampere hours and less, use the 2 amp charge rate. The smaller the battery the greater the risk of harm- ing it by using the 6 amp charge rate.

NOTE: It is important to determine the battery type before charg- ing. (See BATTERY TYPES)

WARNING: This charger will continue to charge even after the battery is charged.

WARNING: Overcharging will damage the battery.

This is a manual (non-automatic) battery charger. A Manual charger will continue to charge and will not shut off. You must keep a visual check on the ammeter to determine when the battery is charged.

AMMETER (See FIGURE 4 & 5)

The ammeter gives a reading of the AMP draw by the battery from the charger. When a fully discharged battery is connected to the charger, the ammeter will read the maximum output rat- ing of the charger, either 2 AMPS or 6 AMPS, depending on the AMP selection. The charge current will gradually taper down as the battery approaches full charge. As the charge current tapers down, the ammeter needle will also move down.

PERCENTOFCHARGE

The percent of charge scale in intended as a visual aid to help simplify reading the state of charge. It is scaled for use with the 6 amp charge rate only. For the 2 amp charge rate use the red triangle. The percent of charge is based on current drawn by the battery. For this reason accuracy will vary with the size and bat- tery type. Typically a 28 ampere hour gel cell battery will draw less current at end of charge then a 140 ampere hour wet cell battery. This means that the indication for a fully charged large battery may be slightly less than 100%.

For the 2 amp charge rate a red triangle has been provided within the green area of the meter scale, it's accuracy has been calibrated for use with small batteries. As a battery takes on a charge, it draws less current from the charger, correspondingly less of the red area will fall under the meter needle.

3

Image 3
Contents AWG size of cord General Battery SafetySchumacher Electric Corporation Length of cord feetCharge Charge Time Recommended Rate Hours Uses Personal Precautions and SafetyGround and AC Power Cord Connections Preparing to ChargePercentofcharge Battery Charger ControlsCharge Rate and Voltage Switch Settings Ammeter SeeCircuit Breaker Battery TypesOperating Instructions Charging Battery in Vehicle Reading AmmeterOperating Instructions Charging Battery OUT of Vehicle Negative Grounded PostPositive Grounded Post Limited Warranty MAINTENANCE/CLEANING InstructionsTroubleshooting Problem Possible SolutionPreparativos Para Cargar Instrucciones Importantes DE SeguridadAdvertencia Riesgos CON Gases Explosivos Precauciones PersonalesInterruptor Para Seleccionar LA Corriente DE Entrada Problemas CON Lista DE ChequeoInstrucciones DE Trabajo Voltaje DE Salida