Schumacher SE-4225 owner manual Calculating Charge Time

Page 14

Using the ENGINE START feature WITHOUT a battery installed in the vehicle could cause damage to the vehicle’s electrical system. NOTE: If you have charged the battery and it still will not start your car, do not use the engine start feature, or it could damage the vehicle’s electrical system.

1.Set the charge rate switch and the timer to the OFF position.

2.With the charger unplugged from the AC outlet, connect the charger to the battery following the instructions given in Section 6 (FOLLOW THESE STEPS WHEN THE BATTERY IS INSTALLED IN A VEHICLE).

3.Plug the charger AC power cord into the AC outlet, and then move the timer switch from OFF to the HOLD position.

4.With the charger plugged in and connected to the battery of the vehicle, set the charge rate selector switch to the engine start position.

5.Crank the engine until it starts or 5 seconds pass. If the engine does not start, wait 3 minutes before cranking again. This allows the charger and battery to cool down.

NOTE: During extremely cold weather, or if the battery is under 2 volts, charge the battery for 5 minutes before cranking the engine.

6.If the engine fails to start, charge the battery for 5 more minutes before attempting to crank the engine again.

7.After the engine starts, move the charge rate selector switch to the off position and unplug the AC power cord before disconnecting the battery clips from the vehicle.

8.Clean and store the charger in a dry location.

NOTE: If the engine does turn over but never starts, there is not a problem with the starting system; there is a problem somewhere else with the vehicle. STOP cranking the engine until the other problem has been diagnosed and corrected.

13.CALCULATING CHARGE TIME

Use the following table to more accurately determine the time it will take to bring a battery to full charge. First, identify where your battery fits into the chart.

NR means that the charger setting is NOT RECOMMENDED.

Find your battery’s rating on the chart below, and note the charge time given for each charger setting. The times given are for batteries with a 50% charge prior to recharging. Add more time for severely discharged batteries.

10

Image 14
Contents Manual del usuario Page Table of Contents Índice Sección PàginaPage Risk of electric shock or fire Important Safety InstructionsPersonal Precautions Risk of explosive gasesPreparing to Charge Follow These Steps When Battery is Installed in Vehicle Risk of explosion and contact with battery acidDC Connection Precautions Charger LocationFollow These Steps When Battery is Outside Vehicle Battery Charging AC ConnectionsParts Tools Needed FeaturesAssembly Instructions Page Page Control Panel Calculating Charge Time Storage Instructions Battery SIZE/RATING Charge RATE/CHARGING TimeMaintenance Instructions Problem Possible Cause REASON/SOLUTION TroubleshootingProblem Possible Cause REASON/SOLUTION Before Returning for Repairs Page Advertencia Instrucciones Importantes DE Seguridad El riesgo de descarga eléctrica o incendioPreparación Para LA Carga Precauciones PersonalesRiesgo de gases explosivos Precauciones DE Conexión EN CC Ubicación DEL CargadorRiesgo de contacto con el ácido de la batería Page Carga DE BATERÍA, Conexiones DE CA Piezas Herramientas Necesarias CaracterísticasInstrucciones DE Montaje Page Page Instrucciones DE Operación Carga Panel DE ControlInterruptor de selección de índice de carga Utilizar la función de encendido de motor 13. Cálculo DE Tiempo DE CargaInstrucciones DE Almacenaje AMPInstrucciones DE Mantenimiento Localización Y Solución DE Problemas Problem Possible Cause REASON/SOLUTION Problem Possible Cause REASON/SOLUTION Antes DE Devolver a Reparaciones