charge should be removed by temporar- ily creating a load on the battery, such as by turning on lights or other accessories. The battery % ranges from 0 to 100.
The battery tester is only designed to
test batteries. Testing a device with a rapidly changing voltage could yield unexpected or inaccurate results.
using the built-in alternator tester
This battery charger has a
TESTING SEQUENCE
There are three basic steps required to use the
1.Connect the charger battery clamps to the battery or charging system. Be sure to follow all of the precautions listed under “OPERATING INSTRUCTIONS”.
2.Connect the charger power cord to a 120V AC
3.Start the vehicle and turn on the vehicle’s headlights. Read the voltage on the digital display or press the DIGITAL DISPLAY button to set the tester to Alternator % and read the alternator percent.
TESTER STATUS LEDs
When the
•The Charged (green) LED will light if the output of the charging system is at the normally desired level.
•The CHARGING (yellow) LED does not light in the alternator test mode.
•The CONNECTED LED lights if the tester detects a connection.
•When the tester digital display is set to voltage, the CHARGED and
CHARGING LEDs won't light (it could be testing a battery or an alternator).
ALTERNATOR TESTING NOTES
•The alternator percent display can range from 0 to 199.
•The DIGITAL DISPLAY cannot be set to Alternator % during charging.
11