Sanyo C1852, C1251 How to connect wiring to the terminal For Indoor Unit, For stranded wiring

WARNING Loose wiring may cause the termi- nal to overheat or result in unit mal-

function. A fire hazard may also exist. Therefore, be sure all wiring is tightly connected.

When connecting each power wire to the corresponding termi- nal, follow the instructions “How to connect wiring to the termi- nal” and fasten the wire securely tight with the fixing screw of the terminal plate.

How to connect wiring to the terminal

a) For Indoor Unit

(1)Cut the wire end with a cutting pliers, then strip the insu- lation to expose the wire about 9/32 in. (7 mm). See the label (Fig. 28) near the terminal plate.

(2)Using a screwdriver, loosen the terminal screw on the ter- minal plate.

(3)Insert the wire and tighten the terminal screw completely using a screwdriver.

STRIP	9/32" (7 mm) (ACTUAL
SIZE	SIZE)

	Fig. 28
mm)	Solid wire
Strip 15/16" (25	Loop
	Insulation

Fig. 29

b) For Outdoor Unit

■For solid core wiring (or F-cable)

(1)Cut the wire end with a cutting pliers, then strip the insu- lation to expose the solid wire about 15/16 in. (25 mm). (Fig. 29)

(2)Using a screwdriver, remove the terminal screw(s) on the terminal plate.

(3)Using the pliers, bend the solid wire to form a loop suit- able for the terminal screw.

(4)Shape the loop wire properly, place it on the terminal plate and fix it securely with the removed terminal screw using a screwdriver.

■For stranded wiring

(1)Cut the wire end with a cutting pliers, then strip the insu- lation to expose the stranded wiring about 3/8 in. (10 mm) and tightly twist the wire ends. (Figs. 30 and 31)

Special

(2) Using a screwdriver, remove the terminal screw(s) on the washer terminal plate.

(3) Using a ring connector fastener or pliers, securely clamp
each stripped wire end with a ring connector. (Fig. 30)	Wire

(4)Place the ring connector wire, and replace and tighten the removed terminal screw using a screwdriver. (Fig. 32)

Stranded wire mm)(10

3/8"Strip

Fig. 30

Twist wire ends

Fig. 31

Screw

Ring connector

Terminal plate

Wire

Fig. 32

Ring

Connector

Screw and special washer

Ring connector

12