Schumacher 600A owner manual Charging Battery Removed From The Vehicle

Charging Battery Removed From The Vehicle:

POSITIVENEGATIVE

BATTERY CHARGER

6. Press the appropriate control but-

tons to select the desired charge rate

and battery voltage. The CHARGING

(yellow) LED should light and the

charging process should start. If the

CONNECTED (red) LED is not on,

BATTERY

24", 6 GAUGE CABLE

POWER CORD

check for correct cable connections.

7. To disconnect the charger, unplug

its power cord before attempting to

disconnect the charger clamps. Then,

TO

GROUNDED

POWER

OUTLET

1.Note the polarity of the battery posts by checking the identification marks on the battery: POSITIVE (POS, P or +) and NEGATIVE (NEG, N or -). The positive post is usually larger than the negative post.

2.Attach at least a 24-inch-long, 6- gauge (AWG), insulated battery cable to NEGATIVE (NEG, N or -) battery post. Rock and twist the clamp back and forth to be sure a solid electrical connection is made.

3.Connect the red (POSITIVE) output clamp to the POSITIVE battery post. Rock and twist the clamp back and forth to be sure a solid electrical con- nection is made.

4.Position yourself as far away from the battery as possible, and then connect the black (NEGATIVE) output clamp to the free end of the cable.

5.Plug the power cord into an AC outlet.

while standing away from the bat-

tery, remove the output clamp from

the NEGATIVE battery post. Finally,

remove the output clamp from the

POSITIVE battery post.

8. Clean and store the charger in a dry

location.

IMPORTANT: Follow all safety instruc- tions and precautions when charging your battery. Wear complete eye protec- tion and clothing protection. Charge your battery in a well-ventilated area.