RIDGID R81030 manual To Install Battery Pack, To Remove Battery Pack, Latches

Page 12

OPERATION

TO INSTALL BATTERY PACK

See Figure 4.

nPlace the battery pack in the screwdriver, aligning raised rib on battery pack with groove in the tool’s battery port.

nMake sure the latches on each side of the battery pack snap into place and the battery pack is secured to the screwdriver before beginning operation.

CAUTION:

When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the screwdriver and latches into place properly. Improper installation of the battery pack can cause damage to internal components.

TO REMOVE BATTERY PACK

See Figure 5.

nLocate the latches on the side of the battery pack and depress both sides to release the battery pack from the screwdriver.

nRemove the battery pack from the screwdriver.

WARNING:

Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side.

SWITCH TRIGGER

See Figure 6.

To turn the screwdriver ON, depress the switch trigger. To turn it OFF, release the switch trigger.

VARIABLE SPEED

The variable speed switch trigger delivers higher speed and torque with increased trigger pressure and lower speed with decreased trigger pressure.

NOTE: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function.

RAISED RIBS

LATCHES

Fig. 4

DEPRESS LATCHES TO

 

RELEASE BATTERY PACK

Fig. 5

 

12

Image 12
Contents OPERATOR’S Manual Table of Contents IntroductionGeneral Safety Rules Work Area SafetyElectrical Safety Personal SafetySpecific Safety Rules Battery Tool USE and CareService Safety Rules for Charger Symbols Symbol Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Features Product SpecificationsSwitch Trigger Assembly Operation Power Indicator Evaluate Indicator Charging Full LED Function of ChargerTo Install Battery Pack To Remove Battery PackLatches Adjustable Torque Clutch Adjusting TorqueAdjusting To Decrease Ring Torque To Increase Reverse ForwardInstalling Bits STICK/PISTOL PositionCoupler Using the Screwdriver Removing BitsLocking Groove BIT CouplerMaintenance General MaintenanceBattery Pack Removal Preparation for Recycling BatteriesWarranty DAY Satisfaction Guarantee PolicyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information