Removing or installing locator assembly
To remove the locator assembly, pull the
locking sleeve forward and then turn it counterclockwise.
To install the locator assembly, screw it clockwise and then push the locking sleeve back in lightly toward the motor. Turn the locking sleeve slightly to match the locking positions and then push in firmly to lock the locator in place.
Locking position Locking s l e e v e - y \
Locator A
Removing or installing bit
CAUTION :
Always be sure that the tool is switched off and unplugged before removing or installing bit.
After removing the locator assembly, pull firmly to remove the magnetic bit holder. Hold the magnetic bit holder in your hand and grasp the bit with a pair of pliers. Pull the bit out of the magnetic bit holder. Sometimes, it helps to wiggle the bit with the pliers as you pull.
Locator
Bit
Magnetic bit holder 2
To install the bit, follow the removal procedures in reverse.
Depth adjustment
Pull the locking sleeve forward and then turn it to adjust the depth.
Locator
Locking
1 | Locking position |
Gear housing | |
|
' / -
5