Reversing switch action
This tool has a reversing switch to change the direction of rotation. Move the revers- ing switch lever to the b position for clockwise rotation or the 'g\ position for counterclockwise.
Reversing switch lever 1
CAUTION :
0 Always check the direction of rotation before drilling.
.Use the reversing switch only when the tool comes to a complete stop. Changing the direction of rotation before the tool stops may ruin the tool.
Operation
Fit the screw on the point of the bit and place the point of the screw on the surface of the workpiece to be fastened. Apply pressure to the tool, Start the tool slowly and then increase the speed gradually. Withdraw the tool as soon as the clutch cuts in.
CAUTION :
0 Use the proper bit for the head of the screw that you wish to use.
0 When fitting the screw onto the point of the bit, be careful not to push in on the screw. If the screw is pushed in, the clutch will engage and the screw will rotate suddenly. This could damage a workpiece or cause an injury.
0 Do not continue unnecessary clutching operation.
NOTE :
Make sure that the bit is inserted straight in the screw head, or the screw and/or bit may be damaged.
MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY, reparis, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
7