Initially, adjust the locator assembly to create a distance of approximately 1 mm (3/64") from the tip of the locator to the base of the screw head. One full turn of the locator equals 1.5 mm (1/16") change in depth. After adjusting the locator assembly, push the locking sleeve in to lock the locator in place. Drive a trial screw into your material or a piece of duplicate material. If the depth is not suitable for the screw, continue adjusting until the proper depth setting is obtained.
1 mm (3/64")
I
I
Switch action | I | I |
Tool speed is increased by increasing pres- |
|
|
sure on the trigger. To start the tool, simply |
|
|
pull the trigger. Release the trigger to stop. |
|
|
For continuous operation, pull the trigger |
|
|
and then push in the lock button. To stop |
|
|
the tool from the locked position, pull the |
| Trigger switch |
trigger fully, then release it. |
| |
|
| |
| I | Lock button |
|
|
CAUTION :
Before plugging in the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.
NOTE :
Even with the switch on and motor running, the bit will not rotate until you fit the point of the bit in the screw head and apply forward pressure to engage the clutch.
6