P 13/ 13
Wiring diagram
[3] Wiring the Lead Wires from LED Circuit on Lead Holder Fig. 31
LED circuit
Make the lead wires so that they cannot be pulled to disconnect LED circuit from Controller when Switch cover is installed.
tab
Hook the lead wires on the five tabs of Lead holder.
Remark:
Do not place the lead wires over the tabs.
tab
Route the lead wires under the pin.
pin
Route the lead wires beside rib (K) and Switch unit (for Clutch).
rib (K)
Switch unit (for Clutch)
tab
Route the lead wires between rib (H) and rib (I), and then rib (I) and rib (J).
rib (H)
rib (I) 
rib (J)
Put Connector and the sag of the lead wires in the space between Housing and rib (L).
rib (L)