INSTALLATION
WIRING DIAGRAM FOR THE E21-NG1 AND E21-LP1
This heater does not require a 120VA.C. supply for operation. In case of a power failure, the burner switch and the optional remote control/ thermostat will continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges.
When connected with 120 volts, the appliance must be electrically grounded in accordance with local codes or, in the absence of local
codes the current CSA C22.1 (in Canada) or with the National Electrical Code ANSI/NFPA
NOTE: This unit is equipped with a heat sensor thermodisc which will prevent the blower from operating until the unit reaches the correct temperature.
#8 Ground Lug | Grounding |
Nut | Lug Detail |
Lockwasher | Fan ground |
|
Star washer
Nut
Power cord ground wire
Star washer
Pilot
Assembly
Thermopile | GasPilot | Electrode |
| Ground | Green |
|
|
| Fan | |
|
|
| |
Neutral |
|
|
|
120V AC Live | Ground |
| |
|
|
| |
60 Hz |
| ON | OFF |
|
| ||
|
| Red Black | Black |
Fan | Rotary Speed | |
Control | ||
Thermodisc | ||
|
Black
Gas
In
|
|
| Thermocouple In |
|
|
| |
|
|
|
| Piezo |
|
|
|
|
|
|
| Ignitor |
|
|
|
P |
| O | H |
|
| Black | ON |
ILO | T |
| N |
|
|
|
|
|
|
| I | White |
|
| Burner |
|
| FO | OL |
|
| ||
|
| F |
|
|
|
|
|
|
|
|
| Brown |
| Red | OFF |
"S.I.T" Valve | Red |
|
|
| |||
|
|
|
| ||||
|
|
|
|
| OFF ON | Thermostat | Remote Transmitter |
|
|
|
| Vent Spill |
| ||
|
|
|
| Switch | Remote | (Millivolt) | (Optional) |
|
|
|
| (Auto Reset) | Receiver | (Optional) | Regency |
|
|
|
|
| (Optional) |
| |
|
|
|
|
| (Millivolt) |
|
|
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
WARNING: Electrical Grounding
Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be plugged directly into
aproperly grounded
FLUE CONNECTOR INSTALLATION
1)Remove the screw holding the fl ue connector plate to the appliance.
2) Slide the plate out and attach to the fl ue liner inside the fi replace to the fl ue collar with three sheet metal screws.
3) Place the appliance on the hearth. Push the appliance into the fi re- place and at the same time slide the plate back onto the appliance.
4)Replace the screw holding the plate just before completely pushing the appliance into the fi replace.
Note: Do not operate unit if flue connector is not fastened in original position.
Regency E21 Gas Fireplace Insert | 9 |