INSTALLATION
7)Tuck the wires into the faceplate to keep them away from the insert using the clip provided. Attach the clip to the rear of the faceplate to ensure that the wires do not touch the side of the unit. See diagram 3.
FLUSH GLASS
1)Install the bottom glass trim onto the glass support.
2)Slide the glass into the bottom glass trim and secure with the glass clips using the 2 phillips head screws at the top.
3)Slide the top glass trim by sliding under the two spring clips.
Note: To
Hearth Trim Option: Hearth Trim is an option that can be used to finish off the installation when the bottom of the fi replace is higher than the hearth or to raise the fi replace. Lay the faceplate side panels fl at, face down on something soft so they don't scratch. Attach the Hearth Trim to the bottom of the faceplate side panels with the screws provided. See Diagram 2. Now attach the assembled pieces to the insert body.
3)Using the connectors provided, join the left side trim (with the ON/OFF switch) to the top trim. See diagram 2. Connect the right side trim to the top trim.
4)Place the trim on the assembled faceplate panels, aligning the wire connections from the switches with the notch on the left side panel.
5)Connect the fan switch wires by taking the black and red wires with the male ends (in the grey harness) and connect them with the wire connectors from the fan speed control.
Diagram 3
8)The power cord should be run behind the faceplate panel.
9)Attach the brass trim to the faceplate by drilling a 1/8" hole through into the faceplate using the hole in the trim as a guide. Fasten the trim to the faceplate panels using the gold plated screws. See diagram 4.
Diagram 4
10)Attach the faceplate panels to the insert body using the 4 remaining black screws. See diagram 5.
11)Push the logo plate into the two holes in the bottom left corner of the faceplate. See diagram 4.
WARNING
The use of substitute glass will void all product warranties.
Diagram 2
6) Connect the ON/OFF switch wires by taking
the black and red wires with the female
ends and connecting them to the ON/OFF
Do not operate the appliance if the glass panel(s) are removed, cracked or broken. Replacement of the glass panel(s) should be done by a qualified
switch.
Diagram 5
service person.
Regency E21 Gas Fireplace Insert
13
