Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Important information – special product care
Your GMC quick charge screwdriver uses capacitors to store the energy that operates the screwdriver. Do not attempt to charge the screwdriver with any other charger than the one supplied. IT IS DANGEROUS TO USE ANY OTHER CHARGER TO CHARGE YOUR TOOL. Ensure you have read all of the safety notes in the previous pages before using the screwdriver.
Charging
IMPORTANT. Before plugging in the charger (7) into the mains power supply always ensure that the mains power switch is turned off.
IMPORTANT. The tool will be fully charged after approximately 45 seconds. The screwdriver can remain in the charger, with the charger turned on without damage being done to the cells (Note. Do not leave the screwdriver in the charger turned on unattended).
1.Place the screwdriver into the charger (7) vertically with the bottom of the screwdriver aligning with the charger as per the picture shown. Push the screwdriver down until it is securely in place.
Note. If the screwdriver is incorrectly orientated the screwdriver will not fit securely in the base.
2.Plug in the charger and switch on at the power supply. The power on indicators (10)
will glow signalling that the charger has power connected to it. The screwdriver will now begin charging. While the screwdriver is charging
the charging indicators (6) will glow signalling that the
screwdriver is in the charging process. When the screwdriver charging process is complete
the charge cycle completed indicator (5) will glow advising that the charge cycle has been
completed.
Note. The charge cycle completed indicator (5) will only glow when the the screwdriver charger (7) is plugged in and is turned on.
The charging time is complete in 45 seconds.
Note. You may use the screwdriver at any time. The charging process does not have to be completed to use the tool and short chargers will not harm the tool.
3.The charging time is approximately 45 seconds. Once the screwdriver has completed it’s charge or once the charge has reached a
suitable level for the task at hand, simply remove the screwdriver from the charger.
Note. Do not leave the charger turned on and unattended.
10