Inserting and removing bits
1.Select an appropriate bit and Insert it into the hexagonal hole in the chuck/bit retainer
(1). The screwdriver is now ready for use.
2.To remove the screwdriver bit you simply remove the existing bit by pulling the bit out of the chuck/bit retainer (1).
Maintenance
•Store the tools, instruction manual and where necessary the accessories in the original packaging. In this way you will always have all the information and parts on hand.
•If the cordset of the charger is damaged or worn, have it repaired or replaced by an authorised service centre in order to avoid a hazard.
•Service to the tool should only be performed by qualified repair persons using identical replacement parts. This will ensure the safety of the power tool.
12