To obtain the best life for the tool
The screwdriver should be placed on charge when ever the tool no longer can perform tasks previously achieved. Do Not completely run down the charge. DO NOT continue to use the screwdriver when the charge is exhausted. The screwdriver does not have automatic spindle lock and using the screwdriver with no charge may damage the tool.
During operation avoid overloading the screwdriver. Doing so will allow you to maximise the charge run time.
Avoid allowing loose items like screws or nails etc. to be stored with tool as these or similar items can short battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in a dry secure place.
Using the screwdriver
Trigger switch
Use the forward/reverse switch
(3)to select the direction of rotation, then pull the trigger
(4).To stop the drill, release the trigger switch (4).
Direction of Rotation/Forward
and Reverse
Note. You can only change the direction of rotation of the drill using the forward/reverse switch
(3)when the trigger (4) is NOT depressed.
This switch will allow you to change the direction of the motor while the trigger switch is not depressed.
The forward mode is used for drilling and tightening screws. The reverse mode is intended for the removal of screws and assisting to remove jammed drill bits.
Adjusting the handle
The handle can be turned to one of two positions to suit the task at hand. The tool can be used as a straight handled screwdriver or as a pistol grip screwdriver.
1.To change the position of the handle, push the handle adjusting switch (2) in and twist the handle to the desired position.
2. Release the switch (2) to lock the handle in the new position.
11