Genie POWERLIFT 900, TRUE, 1200 Red = IntelliCode 1 / Green = IntelliCode, FCC and IC Certified

PROGRAMMING REMOTES

to New Intellicode® 2 Openers.

All type remotes program in the same way.

Bring remote(s) to powerhead location. For Car2U® and HomeLink®, park car outside the garage with the ignition key in the “ACCESSORY” position. Each button must

be programmed individually following steps below.

1	ACTION	LED INDICATION/RESULT
	PROGRAM
	Press & Hold for
	2 seconds or until	BLUE	OFF
	round LED turns blue. SET	OFF	PURPLE
			FLASHING

PROGRAMMING INTELLICODE® 2 REMOTES to Intellicode® 1 (previous model) Openers.

The default setting of Intellicode® 2 must be changed.

The LED color displayed on the remote indicates the IntelliCode® mode.

Red = IntelliCode® 1 / Green = IntelliCode® 2

ACTION	LED INDICATION/RESULT
1 Select a button
NOT prorammed
to a new
Intellicode®2
opener

2	Choose a button on your		Both LEDs Off.
	remote device. Press &	OFF
	release it twice.		OFF
		PURPLE
			OFF
		STEADY
3	Press & Release that same
		DOOR MOVES
	button again.

REMOTE BUTTON IS PROGRAMMED

NOTE: For additional openers—repeat the steps above using a different remote button for each.

2

Press & hold that button for until both the

RED & GREEN LEDs are ON. Release.

STAYS ON RED & GREEN

Press the same remote button 3 times.

RED WHEN BUTTON PRESSED

REMOTE BUTTON IS INTELLICODE® 1

FCC and IC CERTIFIED

This device complies with FCC Part 15 and RSS 210 of Industry Canada. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harful interference to radio or television reception, which may be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:

sRe-orient or relocate the receiver antenna.

sIncrease the separation between the opener and receiver.

sConnect the opener into an outlet on a circuit different from that to which the receiver is connected.

sConsult your local dealer.

3Find the Learn Code Button and

	Learn Code Indicator LED on your	Red Indicator
	door opener.	LED
	– If your Door Opener has a black
	antenna wire and the serial
	number does not start with
	10 or higher, the Learn Code	Located
	Button and Indicator LED are
		on Opener
	located near the antenna. (The	Housing
	light lens may need to be
	opened. If you use an external
	receiver, it may need to be	Learn
	opened to access the Learn
	Code Button and Indicator LED.	Code
	–If Door Opener does not have an	Button
	Antenna, you have an External
	Receiver. The External Receiver
	cover must be removed to
	access the Learn Code Button
	and Indicator LED.
4	Press the	Red Indicator LED BLINKS
	Lean Code
	Button
5	Press the same	Red Indicator LED OFF
	remote button
	twice.
6	Press the same
	remote button	DOOR MOVES
	again.

REMOTE BUTTON IS PROGRAMMED TO OPENER

(Follow the TOP 2 steps above to shift back to Intellicode®2)

9/2011 ©2011 The Genie Company 6