RULES FOR SAFE OPERATION (Continued)
NEVER USE IN AN EXPLOSIVE ATMO- SPHERE. Normal spark4ngof the motor could ignite flammable liquids, gases, or fumes.
mKEEP HANDLES DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always use a clean cloth when cleaning. Never use brake fluids, gasoline,
STAY ALERT. Watch what you are doing and use common sense. Do not operate tool when you are tired, Do not rush,
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditionsthat may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in this instructionmanual.
NDO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF. Have defective switches replaced by an authorized service center.
DRUGS, ALCOHOL, MEDICATION. Do not operate tool while under the influence of drugs, alcohol, or any medication.
DRIVING SCREWS INTO ELECTRICAL
WIRING IN WALLS, CEILINGS, OR OTHER AREAS CAN CAUSE THE SCREWDRIVER BIT
OR COLLET TO BECOME ELECTRICALLY
LIVE. Do not touch metal parts when driving screws into a wall; grasp only the insulated handle(s) or plastic housing when using thistool.
Make sure hidden electrical wiring, water pipes, and mechanical hazards are not in the path of the bit when drivi_j screws into a walt.
•INSPECT FOR and remove all nailsfrom lumber before drivi_3 screws.
IMPORTANT SAFETY RULES FOR BATTERY TOOLS
Battery tools do not have to be plugged into an elentr_caloutlet; therefore, they are always in operating condition. Be aware of possible hazards when not usingyour battery tool or when changing accessories,
•USE ONLY THE CHARGER PROVIDED WITH YOUR BATTERY TOOL. Do not substituteany other charger. Use of another charger could cause batteries to explode causing possible
,,I_erious_i_,iury.
DO NOT PLACE BA'I'FERYTOOLS OR THEIR BA't'rERIESNEAR FIRE OR HEAT. They may explode.
DO NOT CHARGE BA'I'rERYTOOL IN A DAMP OR WET LOCATION.
Your battery tool shouldbe charged in a location where the temperature is more than 5O°F but less than IOO°F.
Under extreme usage or temperature conditions, battery leakage may occur. If liquidcomes in contact with your skin,wash immediateSywith soap and water, then neutralize with lemon juice or vinegar. If liquid gets in your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical attention.
•If carrying your battery tool at your side, make sure it is not running and your finger is not on the switch. Avoid accidental starting.
MSECURE WORK before applying power. NEVER hold workpieca in your hand or across your legs.
WHEN SERVICING USE ONLY IDENTICAL CRAFTSMAN REPLACEMENT PARTS.
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER
SAVE THESE INSTRUCTIONS. This manual contains important safety and operating instructions for battery charger item number
BBefore using battery charger, read all instructions and cautionary markings in this manual, on battery charger, and product using battery charger.
_1, WARNING: To reduce riskof injury,charge only
personal injury and damage.
Do not expose charger to rain or snow.
Use of an attachment not recommended or sold by the battery charger manufacturer may result in a riskof fire, electric shock, or injury to persons.
To reduce risk of damage to charger body and cord, pull by charger body rather than cord when disconnectingcharger.
Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.