READ THIS FIRST
Model G0555LX/G0555LANV |
***IMPORTANT UPDATE*** |
For Machines Mfd. Since 01/14 |
and Owner's Manual Revised 04/13 |
For questions or help with this product contact Tech Support at (570) |
The following change was recently made to this machine since the owner's manual was printed:
•An additional set of 1⁄4" eccentrics has been included with this bandsaw.
Aside from this information, all other content in the owner's manual applies and MUST be read and under- stood for your own safety. IMPORTANT: Keep this update with the owner's manual for future reference.
For questions or help, contact our Tech Support at (570)
Introduction
The model G0555LX and G0555LANV bandsaws come with 3⁄8" eccentrics (Part # P0555LX129) installed behind the guide bearings. An additional set of 1⁄4" eccentrics (Part # P0555LX136) has been included for easier guide bearing adjust- ments with 1⁄8" bandsaw blades.
The reduced thickness of the 1⁄4" eccentrics pro- vides more space for guide bearing adjustments with 1⁄8" blades, helping ensure blade support bearings will not damage the blade tooth set.
Guide Shaft Bracket | |
Guide |
|
Bearing |
|
Eccentrics | Cap Screw |
| |
| |
Cap Screw |
|
Figure 1. Blade support assembly.
Installation
1.DISCONNECT MACHINE FROM POWER!
2.Put on heavy leather gloves and open wheel covers. Remove blade as described in own- er's manual.
3.Remove
4.Loosen cap screw on guide shaft bracket 1⁄2 turn.
5.Remove 3⁄8" eccentrics from guide shaft bracket, and replace with 1⁄4" eccentrics.
6.Retighten cap screw on guide shaft bracket, then
7.Install 1⁄8" blade as described in owner's manual and close wheel covers.
8.Adjust upper and lower guide bearings and support bearings as described in manual.
Copyright © January, 2014 By Grizzly Industrial, Inc.
Warning: No portion of this manual may be reproduced in any shape or form without the written approval of Grizzly Industrial, inc.
#DM16256 printed in Taiwan