General instructions ____________________________________________________________________________________________
The FS800 E/EM floor saw is a professional machine designed for cutting reinforced concrete, asphalt and stone.
This machine may only be used by those who have carefully read this instruction manual and follow its instructions.
If you are unsure about any point please consult the supplier before starting to use the machine.
You must not modify the saw in any way without obtaining written approval from Husqvarna Construction Products Sweden AB. Modifications that are not approved could lead to serious or fatal injury to yourself or others. Husqvarna Construction Products Sweden AB does not accept any liability if the machine is used in any way or for any purpose that does
not comply with these instructions.
1. Description and purpose
The FS800 E/EM electric floor saw is designed for cutting re- inforced concrete, asphalt and other stone material in the building industry.
The saw has a
The floor saw is equipped with a
The FS800 E/EM floor saw has the following controls:
•Height adjustment wheel as shown in figure 1.1.1.
•Blade shaft as shown in figure 1.1.2.
•Alignment guide for cutting a straight line as shown in figure 1.1.4.
•Adjuster screw for the above, as shown in figure 1.1.3.
•Blade guard as shown in figure 1.1.5.
•Control panel with switch, phase inverter and emergency stop as shown in figure 1.1.8.
•Power socket as shown in figure 1.2.1.
•
•Guard for exposed drive shaft as shown in figure 1.2.3.
•Parking brake as shown in 1.2.4.
Figure 1.1
7
1 5 6
8
|
| 3 |
| 4 | ||
2 |
|
| ||||
|
|
|
|
|
|
|
1.1.1.Height adjustment wheel
1.1.2.Pulley shaft
1.1.3.Adjuster screw for alignment guide
1.1.4.Alignment guide
1.1.5.
1.1.6.Lifting handle for blade guard
1.1.7.Guide handle
1.1.8.Control panel with switch, phase inverter and emergency stop
Figure 1.2
2
3
4
1
1.2.1.Power socket
1.2.2.
1.2.3.Guard for exposed pulley shaft
1.2.4.Parking brake
4