___________________________________________________________________________________________________________________________________________________________________________________
Figure 5.2
2 
3 
1
5.2.1.Water pipe for cooling blade
5.2.2.Belt tension adjuster screw.
5.2.3.Belt guard
Figure 5.3
Figure 5.4
1
2
6.Fitting and replacing diamond blades
WARNING! Before attempting to fix a fault you must make sure that the power cables are disconnected to prevent the machine from starting up while you are working.
•Raise the blade guard and secure it with the retaining strap.
•Clean the blade flanges and the blade shaft.
•Fit the blade. NOTE! Direction of rotation. See arrow on body of blade.
•Use the smaller of the two spanners supplied to prevent the blade shaft from turning, and use the larger spanner to undo or tighten the blade flange nut. See figure 6.1.
•Lower the blade guard.
Figure 6.1
7
6
5
3 |
| 2 |
| 1 |
| 4 |
6.1.1.Spanner for holding shaft
6.1.2.Pin spanner for blade flange
6.1.3.Outer blade flange
6.1.4.Diamond blade
6.1.5.Pulley shaft and inner blade flange
6.1.6.Belt guard
6.1.7.Support for blade guard
8