When cutting thin sheet metals such as corrugated metal, always cut them at a position more than 20 mm (25/32") away from the edge. If you cut them at a position closer to the edge, a piece cut off could be sucked into the dust box, causing a severe injury.
More than
20 mm(25/32")
CAUTION:
Never use a deformed or cracked blade. Always replace it with a new one.
*When the battery charge runs low, the blade easily becomes stuck, and the blade tips can break. Always rechargethe battery cartridge when the blade rpm slows down.
Do not stack materials when cutting them.
Do not cut hardened steel.
Do not touch the saw blade, workpiece or cutting chips with your bare hand immediately after cutting; they may be extremely hot and could burn your skin.
Do not connect the saw to a vacuum cleaner when cutting metals.
18