Charging a HOT Battery Pack

OPERATION

When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.

NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARGING A COOL BATTERY PACK” for normal recharging of batter- ies. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check.

TO REMOVE / ATTACH BATTERY PACK

See Figure 5.

To remove:

nLocate latches on side of battery pack and depress both sides to release battery pack from your saw.

nRemove battery pack from your saw.

To attach:

nPlace the battery pack in your saw aligning raised rib on battery pack with groove in saw's battery port.

nMake sure the latches on each side of the battery pack snap into place and battery pack is secured to saw before beginning operation.

P110

CHARGER

GREEN LED

RED LED

YELLOW LED

Fig. 3

BATTERY PACK SHOWN ATTACHED TO CHARGER

P110

CHARGER

BATTERY

PACK

Fig. 4

BATTERY PORT

DEPRESS LATCHES

TO RELEASE

BATTERY PACK

BATTERY

PACK

LATCH

Fig. 5