CLEANING AND STORAGE
WARNING:
To avoid serious personal injury, always turn your saw off and allow it to cool before you clean or do any maintenance on it.
GENERAL
Avoid using strong detergents or solvents when cleaning plastic parts. Most plastics are susceptible to various types of commercial solvents and may be damaged by their use. Use a small brush to clean off the outside of the unit. Household cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can damage plastic housing or handle. Use soft, clean cloths to remove dirt and wipe off any moisture.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc. come in contact with plastic parts. They contain chemicals that can damage, weaken, or destroy plastic.
STORAGE
•Never store the unit with fuel in the tank where fumes may reach an open flame or spark.
•Allow the engine to cool before storing.
•Store the unit locked up to prevent unauthorized use or damage.
•Store the unit in a dry, well ventilated area.
•Store the unit out of the reach of children.
LONG TERM STORAGE
If the unit will be stored for an extended time, use the following storage procedure.
1.Drain all fuel from the fuel tank and drain into a container with the same
2.Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from the carburetor.
3.Allow the engine to cool. Remove the spark plug and put 1 oz. (30 ml.) of any high quality motor oil or
NOTE: Remove the spark plug and drain all of the oil from the cylinder before attempting0 to start the trimmer after storage.
4.Thoroughly clean the unit and inspect for any loose or damaged parts. Repair or replace damaged parts and tighten loose screws, nuts or bolts. The unit is ready for storage.
TRANSPORTING
•Allow the engine to cool before transporting.
•Secure the unit while transporting.
•Drain fuel from unit.
•Tighten fuel cap before transporting.
ACCESSORIES
2 – Cycle Oil
Spark Plug
Fuel Cap
blades Ryobi
Page 17