Ryobi EJ101 specifications California Emission Regulations, Spark Arrestor

Page 3

CALIFORNIA EMISSION REGULATIONS

The engine of your mixer meets the 1995 to 1998 California emissions regulations. To ensure that your unit continues to meet these regulations, refer to the following information and instructions in this operator's manual.

These units are identified by the label on the engine of your product. A typical identification label is shown.

California Proposition 65 Warning:

WARNING

The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

IMPORTANT ENGINE INFORMATION

ENGINE DISPLACEMENT: 31cc

ENGINE FAMILY: SN4031UB24RA; EM

THIS ENGINE CONFORMS TO U.S. EPA PH1

AND 1995-1998 CALIFORNIA EMISSION REGULATIONS FOR ULGE ENGINES. REFER TO OPERATOR’S MANUAL FOR MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.

SPARK ARRESTOR

Note: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington. All U.S. Forest Land and the state of California (Public Resources Codes 4442 and 4443), Oregon and Washington require, by law that certain internal combustion engines operated on forest brush and/or grass-covered areas be equipped with a spark arrestor, maintained in effective working order, or the engine be constructed, equipped and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements could subject you to liability or a fine. This unit is not factory equipped with a spark arrestor. If these items are required in your area, ask your local service dealer to install the Optional Spark Arrestor Kit.

Page 3

Image 3
Contents Save this Manual for Future Reference SpecificationsTable of Contents Spark Arrestor California Emission RegulationsRules for Safe Operation Read ALL Instructions While Operating When Servicing USE only Identical Ryobi Replacement PartsSafety Warnings for Gasoline Engines Before OperatingWhile Operating with Edger ADD-ON Other Safety WarningsKnow Your Reciprocating SAW FeaturesChoke Lever LOCK-ON Button ON/OFF Switch LOCK-OFF UnpackingVariable Speed SwitchLOCK-OFF Lever LOCK-ON ButtonOIL and Fuel Information Stopping Instructions STARTING/STOPPING InstructionsPreparing for Operation Starting InstructionsTo Install Blades Base Shoe AssemblyOperation Lubrication General CuttingPlunge Cutting Metal CuttingMaintenance Maintenance ScheduleFrequency Maintenance Required Refer to Muffler AIR Filter MaintenanceClean Muffler Exhaust Screws Carburetor AIR Filter Cover Element Support ElementsCarburetor Adjustment LOW Speed High Speedneedle Needle Idle Adjusting ScrewReplacing the Spark Plug Accessories Cleaning and StorageCause Action TroubleshootingCause ActionPage Service