Spindle to secure the Saw Blade (20) in place.
To Adjust The Depth Of Cut:
DEPTH
BRACKET (46)
BASE (4) |
|
|
| DEPTH |
|
| |||
|
|
|
| LOCK (44) |
FIGURE G
1.The depth of cut may be adjusted to a maximum of
2.To adjust the depth of cut, raise the
Depth Lock (44) to its unlocked position.
3.Raise the Saw body up from the Base (4), and set the depth of cut using the Depth Bracket (46) provided.
4.Then, lower the Depth Lock to its locked position.
NOTE: Add 1/8” to your depth of cut so the Saw Blade (20) can cut through the material and clear out sawdust from the cut.
To Adjust The Angle Of Cut:
1.The angle of cut may be adjusted from 90 degrees to 45 degrees.
SCALE
BASE
(4)
NUT
(10)
FIGURE H
2.To adjust the angle of cut, loosen the Nut (10). Rotate the Base (4) to set the angle, using the Scale provided. Then, retighten the Nut to lock the Base in position.
To Adjust The Guide Ruler:
BASE
(4)
GUIDE
RULER (1)
SCREW | FIGURE I |
(3) |
1.The Guide Ruler (1) is used for making cut parallel to a workpiece edge at a chosen distance.
2.To use the Guide Ruler (1), loosen the Screw (3). Slide the arm of the Guide Ruler through the openings on each side of the Base (4) and achieve the desired cutting distance using the Scale. Then, retighten the Screw to lock the Guide Ruler in position.
NOTE: The Guide Ruler can be used from either side of the Base.
SKU 95004 | For technical questions, please call | Page 12 |