16)Do not charge battery pack when the temperature is BELOW 0°C (32°F) or ABOVE 40°C (104°F). This is very important.
17)Do not incinerate the battery pack. It can explode in a fire.
18)Avoid dangerous environment. Do not use charger in damp or wet locations.
19)The charger is designed to operate on standard household electrical power only. Do not attempt to use it on any other voltage!
20)Do not abuse cord. Never carry char- ger by cord or yank it to disconnect from outlet. Keep cord away from heat, oil and sharp edges.
21)Charge the battery pack in a well ventilated place, do not cover the charger and battery pack with a cloth, etc., while charging.
22)Use of an attachment not recom- mended may result in a risk of fire, electric shock, or injury to persons.
23)Do not short the battery pack. A bat- tery short can cause a large current flow, over heating and burns.
24)NOTE: If the supply cord of this appli- ance is damaged, it must only be re- placed by a repair shop appointed by the manufacturer, because special purpose tools are required.
25)TO REDUCE THE RISK OF ELEC- TRIC SHOCK, THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER).
This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
WARNING:
•Do not use other than the Panasonic battery packs that are designed for use with this rechargeable tool.
•Panasonic is not responsible for any damage or accident caused by the use of the recycled battery pack and the counterfeit battery pack.
•Do not dispose of the battery pack in a fire, or expose it to excessive heat.
•Do not drive the likes of nails into the battery pack, subject it to shocks, dismantle it, or attempt to modify it.
•Do not allow metal objects to touch the battery pack terminals.
•Do not carry or store the battery pack in the same container as nails or similar metal objects.
•Do not charge the battery pack in a
•Never use other than the dedicated charger to charge the battery pack. Otherwise, the battery may leak, overheat, or explode.
•After removing the battery pack from the tool or the charger, always reat- tach the pack cover. Otherwise, the battery contacts could be shorted, leading to a risk of fire.
•When the Battery Pack Has Deteri- orated, Replace It with a New One. Continued use of a damaged battery pack may result in heat generation, ignition or battery rupture.
V. ASSEMBLY
Attaching or Removing Bit
NOTE:
When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center po- sition (switch lock).
This tool is equipped with a keyless drill chuck.
1.Attachment
Insert the bit and turn the lock collar clockwise (looking from the front) to tighten firmly until it stops clicking.
- 7 -
EY7442_7450_7950(UL).indb 7