Panasonic EY6932 operating instructions Lamp Indications

Page 9

Battery pack

To AC outlet

Battery charger

3.During charging, the charging lamp will be lit.

When charging is completed, an internal electronic switch will au- tomatically be triggered to prevent overcharging.

Charging will not start if the battery pack is warm (for example, immedi- ately after heavy-duty operation).

The orange standby lamp will be lit until the battery cools down. Charging will then begin automati- cally.

4.When charging is completed, the charging lamp will start flashing rapidly.

5.When in any of the conditions that battery pack is too cool, or the bat- tery pack has not been used for a long time, the charging lamp starts flashing slowly to indicate protective charging. Protective charging takes longer to fully charge the battery pack, than the standard charging

time. (Max. charging time is ap- prox. 90 minutes).

If a fully charged battery pack is inserted into the charger again, the charging lamp may light up and then flash slowly. After sev- eral minutes, the charging lamp may flash quickly to indicate the charging is completed.

6.If the charging lamp does not light immediately after the charger is plugged in, or if after the standard charging time the lamp does not go off, consult an authorized dealer.

Note: When charging a cool battery pack (below 15°C (41°F) in a warm place, leave the battery pack at the place and wait for more than one hour to warm up the battery to the level of the ambient temperature. (Battery pack may not be fully charged.)

Cool down the charger when charging more than two bat- tery packs consecutively.

Do not insert your fingers into contact hole, when holding charger or any other occa- sions.

CAUTION: Do not use power source from an engine generator. Do not cover vent holes on the charger and the battery pack.

. LAMP INDICATIONS

 

 

 

 

 

 

 

 

 

 

 

 

 

Charger is plugged into a wall outlet.

 

Flashing

 

 

 

 

 

Ready to charge.

 

 

 

 

 

 

Now charging

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Lit

 

 

 

 

 

 

 

 

 

 

 

 

Charging is completed.

Flashing quickly

 

 

 

 

 

 

 

 

 

 

 

 

 

Protective charging

 

 

 

 

 

 

 

 

 

 

 

 

 

Flashing slowly

 

 

 

 

 

 

 

 

 

 

Battery pack is warm. Charging will begin

 

 

 

 

 

 

 

 

 

 

 

 

 

when temperature of battery pack drops.

 

 

Lit

 

 

 

 

 

 

 

 

 

 

 

 

Charging is not possible. Clogged with

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Flashing

 

 

 

 

 

 

 

 

dust or malfunction of the battery pack.

- 9 -

Image 9
Contents Page Keep your work area clean and well lit Read and understand all instructionsCluttered benches and dark areas invite accidents Specific Safety Rules Do not use tool if switch does not turn it on or offMany accidents are caused by poorly maintained tools Save These Instructions Do not attempt to disassemble the battery pack housing Assembly Functional DescriptionAttaching or removing bit Switch Operation Attaching or removing battery packClutch Torque Setting OperationFor Appropriate use of Battery pack Speed SelectionCharging Lamp Indications Use only a dry, soft cloth for wiping Maintenance AccessoriesMain Unit SpecificationsDAY Quality Satisfaction Guarantee