P 9/ 14
Repair
[3]DISASSEMBLY/ASSEMBLY
[3]-8. Swash Bearing Section (cont.)
DISASSEMBLING
6)Move Piston cylinder to the rear dead center position (Fig. 32).
7)Remove Swash bearing section from Inner housing by pulling in the direction of the arrow. Then, remove Change plate from the groove of Clutch cam. (Fig. 33).
Fig. 32
Piston cylinder |
in the rear dead center position |
Piston |
cylinder |
Swash bearing section |
Fig. 33
Swash bearing section | Inner housing complete |
Change plate
Change plate 
Clutch cam
8)Remove Ball bearing 606ZZ from Gear housing complete using the removed Swash bearing section as a jig as follows;
*Insert Cam shaft of Swash bearing section into the Ball bearing again.
*Tilt the Ball bearing a little bit by moving Swash bearing section as illustrated to left in Fig. 34.
*Ball bearing 606ZZ can now be removed by lightly tapping the edge of Gear housing complete with plastic hammer as illustrated to right in Fig. 34.
Fig. 34
Gear housing 
complete
Swash bearing section used as a jig
Ball bearing 606ZZ
9)Remove Ring 8 using 1R022, 1R023, 1R281 and arbor press as illustrated in Fig. 35.
10)Remove Ball bearing 608ZZ using 1R269. Flat washer 8 and Bearing retainer can now be removed by hand. (Fig. 36)
Fig. 35
Ring 8 |
|
|
1R022 | 1R281 | Ring 8 |
|
| |
1R022 |
|
|
Ball bearing |
|
|
608ZZ |
|
|
1R023 |
|
|
Fig. 36
Ball bearing 608ZZ
1R269
Bearing retainer
Flat washer 8