Swash Bearing Section | Makita BHR241Z, BHR241RFE specs

P 8/ 14

2)Push Ring spring 28 with Piston cylinder until it fits to the inner groove of Tool holder complete. (Fig. 29)

Fig. 29

Note: Use an extra Piston cylinder as a jig. Never use Piston cylinder that is to be assembled to the machine.

Piston cylinder as a repairing jig

Inner groove of

Piston cylinder as a repairing jig

Ring spring 28

Tool holder complete

Ring spring 28

O ring case

[3] -8. Swash Bearing Section

1)Disassemble Tool holder section as illustrated in Fig. 3.

2)Disassemble Change lever as illustrated in Figs. 4 and 5.

3)Separate Gear housing complete from Motor housing complete. And then, remove Armature from Gear housing complete. (Refer to Figs. 8 to 10.)

4)Remove Stop ring E-4, Flat washer 5 and Compression spring 6 from pin of Inner housing complete. (Fig. 30)

5)Remove two M4x12 Hex socket bolts that fasten Bearing retainer to Inner housing complete. (Fig. 31)

Fig. 30

Pin of Inner housing complete

Stop ring E-4

Flat washer 5

Compression spring 6

Fig. 31

M4x12 Hex socket head bolt (2 pcs.)

Change plate