Assembly

*If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge from the fast charger.

*If the charging light flashes alternately in green and red color a problem exists and charg- ing is not possible. The terminals on the charger or battery cartridge are clogged with

dust or the battery cartridge is worn out or damaged.

*If you wish to charge two battery cartridge, allow 15 mimutes between charging on the fast charger.

Installing or removing driver bit or drill bit

CAUTlON:

Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit

Hold the ring and turn the sleeve counter- clockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the sleeve clock- wise to tighten the chuck.

To remove the bit, hold the ring and turn the sleeve counterclockwise.

When not using the driver bit, keep it in the bit holders. Bits 45 mm (1-3/4") long can be kept there.

Tighten

Slee:ve

Ring -

Bit -

I Bit holder 2