Switch action |
|
| 1 |
|
|
| |
Tool speed is increased by increasing pres- |
|
|
|
sure on the trigger. To start the tool, |
|
|
|
simply pull the trigger. Release the trigger |
|
|
|
to stop. |
|
|
|
Trigger switch | I; | I |
|
CAUTION :
Before inserting the battery cartridge into the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.
Reversingswitch action
This tool has a reversing switch to change the direction of rotation. Move the revers- ing switch to the left for clockwise rotation or to the right for counterclockwise.
CAUTION :
*Always check the direction of rotation before operation.
.Move the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool.
Speed change |
|
|
| |
To change the speed, slide the speed |
|
|
| |
change lever to the "H" side for high speed |
|
|
| |
or "L" side for low speed. To slide the |
|
|
| |
speed change lever easily, pull the trigger |
|
|
| |
slightly while pushing the speed change |
|
|
| |
lever. Be sure that the speed change lever is |
|
|
| |
set to the correct position before operation. |
| i | \\ | |
Use the right speed for your job. | Speed change lever | |||
|
|
CAUTION :
Always set the speed change lever fully into the correct position. If you operate the tool with the speed change lever positioned halfway between the "H" side and "L" side, the tool may be damaged.
8