Makita 6311DW dimensions Fastening torque can be adjusted in six

Speed change

To change the speed, slide the speed change lever to the "H" side for high speed or "L" side for low speed. To slide the speed change lever easily, pull the trigger slightly while pushing the speed change lever. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job.

CAUTION:

Always set the speed change lever fully into the correct position. If you operate the tool with the speed change lever positioned halfway between the "H" side and "L" side, the tool may be damaged.

Adjustingfasteningtorque	Pointer 77Drill marking
The fastening torque can be adjusted in six
stages by turning the adjusting ring so that
the pointer on the adjusting ring points to

anumber on the tool body. The fastening torque is minimum when the pointer points to the number 1 and maximum when it points to the a\- marking. The clutch will slip at varying torque levels when the pointer is set a t the numbers 1 to 5. The clutch is designed not to slip a t the markina.

Before-actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application.

NOTE:

The adjusting ring cannot be locked with the pointer positioned half-way between the numbers.

Screwdrivingoperation

Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increasethe speed gradually. Release the trigger as soon as the clutch cuts in.

8