Makita 6311DW dimensions Reset button

Page 9

Installingor removing battery cartridge

0 Always switch off the tool before insertion or removal or the battery cartridge.

.To remove the battery cartridge, pull out the set plate on the tool and grasp both sides of the cartridge while withdrawing it from the tool.

.To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Snap the set plate back into place. Be sure to close the set plate fully before using the tool.

0 Do not use force when insertingthe battery cartridge.

If the cartridge does not slide in easily, it is not being inserted correctly.

Charging

Battery cartridge

m

 

Plug the fast charger into your power

 

 

 

source. Insert the battery cartridge so that

 

 

the plus and minus terminals on the bat-

 

 

tery cartridge are on the same sides as their

 

 

respective markings on the fast charger.

 

 

Insert the cartridge fully into the port so

 

 

that it rests on the charger port floor.

 

 

Press the start button (red). The charging

Reset button

 

light will come on and charging will begin.

 

 

 

If the charging light does not come on, press the reset button (yellow) first, then the start button (red). If the charging light goes out within 10 seconds even after pressing the reset button and start button a couple of times, the battery cartridge is dead. (CAUTION: Wait for more than 5 seconds after the charging light goes out to press the reset button again.) Replace it with a new one. When the charging light goes out after about one our, you may remove the fully charged battery cartridge.

After charging, unplug the charge from the power source.

CAUTION:

0 Your new battery cartridge is not charged. You will need to charge it before use.

0 When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, the charging light may not come on. If this occurs, iust press the reset button (yellow) first, then the start button (red) as described before. Charging will begin.

0 Do not keep the button pressed in with tape, etc. or the circuit will not function pro- perly. Also, a malfunction of the charger may result possibly causing overheating, etc.

0 If you try to charge a cartridge from a just-operated tool, sometimesthe charging light will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it and try to charge it once more.

0 When you charge a new battery cartridge or a battery cargridge which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.

0If you wish to charge two battery cartridges, allow 15 minutes between chargings on the fast charger.

6

Image 9
Contents Equipped with Electric Brake Safety Instructions Keyless Chuck System Plug the fast charger into the proper A/C 3J%-fzE Page Important Safety Instructions For Charger Battery Cartridge Additional Safety Rules For Charger & Battery Cartridge Reset button Page Fastening torque can be adjusted in six Drilling operation Page Maintenance Hook Cordless Driver Drill Spur Gear 4 Recycling the Battery