SECO-LARM USA SA-025EQ manual Free Egress Input N.C.+, Reset Input N.C.+, Initiate Input N.C.+

ENFORCER Delayed Egress Timer

Free Egress Input (N.C.+):

∙Connect a N.C. toggle switch between the free egress input and the positive terminal.

∙The free egress input allows the lock to be put in the free egress mode. This bypasses any delays and alarms, allowing the initiate device to act as a simple egress device.

∙In the free egress mode, the lock is released as soon as the initiate device is triggered.

∙The door will relock after 5 seconds.

∙This can be used in conjunction with a timer (such as the SA-027Q annual timer) to allow free egress during the day, but restricted access at night.

∙The remote alarm will also signal during free egress if the door is left open longer than 5 seconds (the lock status jumper must be ON for this to occur).

∙If not used then a jumper must be installed between the free egress input and the positive power input terminal.

Reset Input (N.C.+):

∙Connect a N.C. switch between the reset input and the positive terminal.

∙The reset input is used to reset the SA-025EQ.

∙The reset input is only necessary in the standard relock mode.

Initiate Input (N.C.+):

∙Connect a N.C. device (such as the SD-961A-36 Push-to-Exit Bar) between the initiate input and the positive terminal.

∙The initiate input is used to activate the SA-025EQ.

∙To activate, hold down the initiate input for the duration of the nuisance delay timer.

Bypass Input (N.C.+):

∙Connect a N.C. switch between the bypass input and the positive terminal.

∙The bypass input is used to bypass the SA-025EQ and allow unrestricted entry and exit via the door.

∙When the bypass input is activated, the lock will immediately release. It will remain released until the bypass input is deactivated.

∙The bypass input will not trigger the remote alarm or local alarm.

∙If not used then a jumper must be installed between the bypass input and the positive power input terminal.

Lock Status Input (N.C.+):

∙Connect a N.C. magnetic contact (such as the SM-200Q) between the lock status input and the positive terminal.

∙The lock status input will detect if the door on which the magnetic contact is mounted is closed in order to trigger the relock functions.

Power Input (12~24 VAC/VDC):

∙The SA-025EQ is powered by a 12~24 VAC or VDC power supply.

∙LED 1 (blue) is on when the SA-025EQ is powered.

SECO-LARM U.S.A., Inc 9