SECO-LARM USA SA-025EQ Lock Status Jumper, Security Mode Jumper, Local Alarm Output Type Jumper

ENFORCER Delayed Egress Timer

Lock Status Jumper:

∙When the lock status jumper is ON, the lock status input will detect whether the door is closed and will trigger relock functions.

∙The lock status input may be bypassed in order to keep the door unlocked for an indefinite period of time without activating the remote alarm output.

∙To bypass the lock status input, set jumper 1 to OFF.

∙The lock status input must be ON for BOCA Mode (See pg. 5, Relock Modes).

Default: OFF

Jumper 1

Security Mode Jumper:

∙To activate security mode, set jumper 2 to ON.

∙In security mode, after the initiate device (such as a push-to-exit bar) has been triggered and the pre-delay timer has ended, the lock will remain active until the initiate device has been triggered a second time.

∙When security mode is OFF, the initiate device must only be activated once.

Default: OFF

Jumper 2

Local Alarm Output Type Jumper:

∙The SA-025EQ is equipped with a 500mA@12VDC transistor ground output for a local alarm, typically an audible or visual device.

∙The local alarm output can be set for steady or pulsing. When set ON, the local alarm pulses during the pre-delay, gradually pulsing faster until the end of the pre-delay time. The local alarm will continue signaling steady 5 seconds after the lock has been released. When set OFF, the local alarm is steady during the pre-delay time and for 5 seconds after the lock has been released.

∙LED 4 is on when the local alarm output is active.

∙The local alarm signals when the pre-delay bypass is used (see pg. 9).

∙To set the local alarm output type ON (steady) or OFF (pulsing), use jumper 3 on the right side of the circuit board.

Default: OFF

Jumper 3

SECO-LARM U.S.A., Inc 7