ENFORCER Delayed Egress Timer
Installation:
Removing the housing
To remove the housing cover from the
Mounting
If mounting is necessary, secure two screws (not included) through the two screw holes located on the side of the unit to a mounting surface.
Wiring Diagram:
Push tab inward.
Remote alarm relay output
(10A@24VDC, Form C Relay, NO/NC/COM)* (see pg. 8)
Lock relay output
(10A@24VDC, Form C Relay, NO/NC/COM)* (see pg. 8)
Local alarm output (500mA@12VDC, transistor ground) (see pg. 8)
Free egress input (N.C.+) (see pg. 9)
Reset input (N.C.+) (see pg. 9)
Initiate input (N.C.+) (for unlock device) (see pg. 9)
Bypass input (N.C.+) (see pg. 9)
Lock status input (N.C.+) (see pg. 9)
Power input (12~24 VAC/VDC) (see pg. 9)
| *Normally energized. (Screen print refers to energized state as normal.) |
4 |