Charging

Connect the charging plug to the charging connector, then plug in the charger to the power receptacle. Chargingtakes 3 hours.

CAUTION:

The battery in your new tool is not fully charged. You will need to charge it before use.

Do not operate the tool during charging.

Overcharging more than 2 days consider- 1 ably shortens the battery service life.

Always unplug the charger after completing the charge.

Installing or removing driver bit

CAUTION :

When installing or removing the bit, be careful not to touch the trigger switch.

To install the bit, place it in the chuck as

far as it will go. Tighten the chuck by-Chuck kev hand. Place the chuck key in each of the

three holes and tighten clockwise.

Be sure to tighten all three chuck holes evenly.

To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand.

After use, return the chuck key to the strorage cavity on the tool.