CAUTION :
Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pres- sure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool.
the time of hole breakthrough. to break through the workpiece.
.A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. However,the tool may back out abruptly if you do not hold it firmly,
0 Always secure small workpieces in a vise or similar
Screwdriving operation
Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool. Release the switch trigger just as the screw bottoms out. If the switch trigger is not released, the screw may strip out the hole or the screw and/or bit may be damaged.
8