Installing or removing the drill bit
CAUTION :
Always be sure that the tool is switched off and the batterv is disconnected from the tool before installing or removing the bit.
To install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand. Place the chuck key in each of the three
holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return it to the original position
Switch action
To start the tool, simply pull the trigger. Tool speed is increased by increasing pressure on the trigger. Release the trigger to stop.
CAUTION :
Before connecting the battery to the tool, actuates properly and returns to the "OFF"
Reversing switch action
This tool has a reversing switch to change the direction of rotation. Move the revers- ing switch lever to the right for clockwise rotation or to the left for counterclockwise rotation.
always check to see that the switch trigger position when released.
Aeversing switch lever
/
CAUTION :
Always check the direction of rotation before operation.
*The reversing switch lever cannot be moved while the trigger is pulled.
Use the reversing switch only after the tool comes to complete stop. Changing the direction of rotation before the tool stops may damage the tool.
9