Holding tool
Hold the tool as shown in the figure.
When drilling a large diameter hole, hold the tool firmly with both hands.
Switch action
Move the reversing switch lever to the "FWD" position for clockwise rotation or the "REV" position for counterclockwise. To start the tool, simply pull the trigger. Release the trigger to stop. When the revers- ing switch lever is in the neutral position, the tool will not start even if you pull the trigger.
Reversing | I\ \ | I | ill |
switch lever |
FWD
CAUTION :
0 Always check the direction of rotation before drilling.
*Use the reversing switch lever only when the tool comes to a complete stop. Changing the direction of rotation before the tool stops may ruin the tool.
When not operating the tool, keep the reversing switch lever in the neutral position.
7