Charging
Connect the charging plug to the charging connector, then plug in the charger to the power receptacle. Charging takes 3 hours.
CAUTION:
*The battery in your new tool is not fully charged. You will need to charge it before use.
Do not operate the tool during charging.
Overcharging more than 2 days consider- ably shortens t h e battery service life. Always unplug the charger after completing the charge.
Installing or removing driver bit or drill bit
CAUTION :
Charging plug
Always set the reversing switch lever to the neutral position before installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place Sleeve
the bit in the chuck | as far as it will go. | |
Hold the ring firmly | and turn | the sleeve |
clockwise to tighten the chuck. | Ring | |
To remove the bit, hold the ring and turn the sleeve counterclockwise.
6