Lithium Battery Safety and
Charging Instructions
1.Do not leave Drill/Driver unattended while charging.
2.Battery charging should be done by adults only.
3.Charge on
4.Turn charger off when battery is charged, and unplug charger from
5.Disconnect AC wall chargers from outlets while not in use.
6.If
7.Follow instructions for charging battery. Do NOT charge longer than recommended.
Charging
1.The Battery Pack (44) requires charg- ing before the initial use. The recom- mended initial charge time is eight hours, prior to initial use of the Cord- less Drill/Driver. Place the Charger on a solid surface such as a garage floor; never on anything flammable.
Note: Always switch to a fresh battery when tool performance begins to diminish. Severe heat is destructive to batteries; the more heat generated, the faster the battery will lose power. A battery that gets too hot can be permanently damaged. Never over- discharge a battery by using the tool after performance decreases. Never
attempt to discharge a battery by continuing to pull the trigger. When tool performance begins to diminish, stop the tool, recharge the battery, and use a fully charged battery for optimal performance.
2.When the Battery
3.Charging room temperature: 50° F. – 104° F.
4.Depress both buttons at the rear of the Battery Pack and slide the unit down to detach from the Drill/Driver.
5.The Battery Pack can only fit into the
Charger (57) in one position, insert into Charger, plug Charger into Adapter (60), and plug Adapter into any standard electrical outlet.
6.While charging, the Battery
Pack, Charger, and Adapter may be- come warm to the touch. This is nor- mal, and does not indicate a problem.
7.When the Battery Pack is in the Char- ger, both the red and green lights on the Charger will be illuminated while charging, when the Battery Pack is fully charged the red light will turn off, indicating that the Battery Pack is ready for use. Once the Battery Pack
SKU 98544 | For technical questions, please call | Page 10 |