21.Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with a sharp cutting edge are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged tools “Do not use” until repaired.
22.Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool’s operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly maintained tools.
23.Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one tool may become hazardous when used on another tool.
SERVICE
24.Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury.
25.When servicing a tool, use only identical replacement parts. Follow instructions in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury.
SPECIFIC SAFETY RULES
1.Hold tool by insulated gripping surfaces when performing an operation where the cutting tools may contact hidden wiring or its own cord. Contact with a ‘live’ wire will make exposed metal parts of the tool ‘live’ and shock the operator.
2.Always wear ANSI approved safety impact eye goggles and full face shield when operating this product.
3.Maintain labels and nameplates on the Drill. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
4.Do not reach under or behind the material being drilled.
5.Make sure the workpiece is free from nails and any other foreign objects which can damage a drill bit.
6.Maintain a firm grip with both hands on the Drill, and position your body and arm to allow you to resist torque forces.
7.Do not use a dull or damaged drill bits. Unsharpened or damaged drill bits cause excessive friction and binding.
8.Use caution when drilling into existing walls or other blind areas. Check for unexposed electrical wires and cables in the drilling path before drilling.
SKU 92956 | For technical questions please call | PAGE 5 |