Craftsman 315.115510 manual Save TH I ST UCT

Page 5

_1_ WARNING!READANDUNDERSTAND ALL

INSTRUCTIONS. Failure to follow aii instructions listed below, may result in electric shock, fire and/or serious personal injury.

[] Before using battery charger, read all instructions and cautionary markings in this manual, on battery charger, battery, and product using battery to prevent misuse of the products and possible injury or damage.

CAUTION: To reduce the risk of electric shock

or damage to the charger and battery, charge only nickel-cadmium rechargeable batteries as specifically designated on your charger. Other types of batteries may burst, causing personal injury or damage.

[] Do not use charger outdoors or expose to wet or damp conditions. Water entering charger will increase the risk of electric shock.

[] Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to persons. Following this rule will reduce the risk of electric shock, fire, or serious personal injury.

[] Do not abuse cord or charger. Never use the cord to carry the charger. Do not pull the charger cord rather than the plug when disconnecting from receptacle. Damage to the cord or charger could occur and create an electric shock hazard. Replace damaged cords

immediately.

[] Make sure cord is located so that it will not be stepped on, tripped over, come in contact with sharp edges or moving parts or otherwise subjected to damage or stress. This will reduce the risk of accidental falls, which could cause injury, and

damage to the cord, which could result in electric shock.

[] Keep cord and charger from heat to prevent damage to housing or internal parts.

[] Do not let gasoline, oils, petroleum-based products, etc. come in contact with plastic parts. They contain chemicals that can damage, weaken, or destroy plastic.

[] An extension cord should not be used unless

absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If

extension cord must be used, make sure:

a. That pins on plug of extension cord are the same number, size and shape as those of plug on charger.

b. That extension cord is properly wired and in good electrical condition; and

c.That wire size is large enough for AC ampere rating of charger as specified below:

Cord Length (Feet) 25' 50' 100'

Cord Size (AWG) 16 16 16

NOTE: AWG = American Wire Gauge

[] Do not operate charger with a damaged cord or plug, which could cause shorting and electric shock. If

damaged, have the charger replaced by an authorized serviceman.

[] Do not operate charger if it has received a sharp

blow, been dropped, or otherwise damaged in any way. Take it to an authorized serviceman for electrical check

to determine if the charger is in good working order.

[] Do not disassemble charger. Take it to an authorized serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.

[] Unplug charger from outlet before attempting any maintenance or cleaning to reduce the risk of electric shock.

[] Disconnect charger from the power supply when not in use. This will reduce the risk of electric shock

or damage to the charger if metal items should fall into the opening. It also will help prevent damage to the charger during a power surge.

[] Risk of electric shock. Do not touch uninsulated

portion of output connector or uninsulated battery terminal.

[] Save these instructions. Refer to them frequently and use them to instruct others who may use this tool. If you loan someone this tool, loan them these instructions also to prevent misuse of the product and possible injury.

IPORTANT SAFETY iNSTRUCTiON

[] SAVE TH I ST UCT

This manual contains important safety and operating instructions for battery charger 1425301 (item No. 911041) and 315.115730 (Item No. 140301003).

[] Before using battery charger, read all instructions and cautionary markings on battery charger, battery, and product using battery.

3. CAUTION: To reduce the risk of injury, charge only nickel-cadmium rechargeable batteries. Other types of batteries may burst, causing personal injury or damage.

5

Image 5
Contents Perators MAN AL Free Repair ONE-YEARFULL Warranty on Craftsman ToolCharger ModelAccessories ServiceUnder extreme ElectricalSave TH I ST UCT DESIGNATION/EXPLANATION Symbol NameSymbol Signal Meaning ServiceLevel Battery PackTWO-SPEED Keyless ChuckPacking List Knowyour DrillSee Figure Applications Charging a Cool Battery PackCharging the Battery Pack Shownin Charger Latches Depresslatchesto ReleasebatterypackGreenled LEDReverse Variablespeed Switchtrigger Switch TriggerKeyless Chuck UnlockchuckTo Decrease Adjusting Torque Adjusting TorqueTWO=SPEED Gear Train GEARTRAINHI-LOLDDrillbit Keyless Chuck Unlockchuck DrillingJaws Releasecollar Lock Tighten Chuck BodyLevel Wood Drilling Batteries General MaintenanceBattery Pack Removal and Preparation For Recycling Mallet See Figures 13Chuck Hexkeychuck Keyless MalletCRAFTSMAN3/8 in., 19.2 Volt Cordless Drill Model no See Back page for Parts Ordering Instructions Parts List