LEVEL__
LEVEL
Fig. 11
Fig. 12
WOOD DRILLING
For maximum performance, use high speed steel bits for wood drilling.
[] Select normal drilling mode.
[] Begin drilling at a very low speed to prevent the bit
from slipping off the starting point. Increase the speed as the drill bit bites into the material.
[] When drilling through holes, place a block of wood behind the workpiece to prevent ragged or splintered edges on the back side of the hole.
METAL DR(LLiNG
For maximum performance, use high speed steel bits for metal or steel drilling.
[] Select normal drilling mode.
[] Begin drilling at a very low speed to prevent the bit from slipping off the starting point.
[] Maintain a speed and pressure which allows cutting without overheating the bit. Applying too much pressure will:
• Overheat the drill; Wear the bearings; Bend or burn bits; and
Produce
[] When drilling large holes in metal, start with a small bit, then finish with a larger bit. Also, lubricate the bit with oil to improve drilling action and increase bit life.
15