SWITCH
See Figure 2.
To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.
SELECTOR
BATTERY
PACK
LATCHES
CENTER POSITION
(LOCK) |
|
SWITCH |
|
TRIGGER | Fig. 2 |
VARIABLE SPEED |
|
This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned, this is a normal part of the switch function.
TO INSTALL BATTERY PACK
•Lock switch trigger on your drill by placing the direction of rotation selector in center position. See Figure 2.
•Place battery pack in your drill. Align raised rib inside drill with groove on battery pack, See Figure 3.
DEPRESS |
|
TO RELEASE |
|
BATTERY PACK | Fig. 3 |
|
•Make sure the latches on each side of your battery pack snap in place and battery pack is secured in drill before beginning operation.
,_ CAUTION: When placing battery pack in your drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
•Lock switch trigger on your drill by placing the direction of rotation selector in center position. See Figure 2.
•Locate latches on end of battery pack and depress to release battery pack from your drill. See Figure 3.
•Remove battery pack from your drill.
8