Craftsman 315.11461 Drill-Driver, Know Your DRILL-DRIVER, Switch Lock, Variable Speed

Page 7

DRILL-DRIVER

315.114610

Chuck

3/8 in. Keyiess

Motor

DC Motor

18 Volt

Gear Train

Two Speed

No Load Speed

0-350/min.

(Low)

 

0-1300/min

(High)

Clutch

24 Positions

KNOW YOUR DRILL-DRIVER

See Figure 1.

Before attempting to use your drill-driver, familiarize yourself with all operating features and safety requirements.

KEYLESS CHUCK

Your drill-driver has a keyless chuck that allows you to hand tighten or release drill bit in the chuck jaws.

SWITCH

To turn your drill-driver ON, depress the switch trigger. Release switch trigger to turn your drill-driver OFF.

SWITCH LOCK

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use.

VARIABLE SPEED

This toot has a variable speed switch that delivers higher speed with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

TWO SPEED GEAR TRAIN

Your drill-driver has a two speed gear train designed for drilling or driving at HI or LO speeds. A slide switch is located on top of your drill to select either HI or LO speed.

Maximum

Torque

337 in.lb.

 

 

CHARGER

Item No.

9

11379

 

 

(1426161

)

 

Rating

 

120 V, 60 Hz, AC only

Charging

Voltage

18 Volt

 

 

Charge Rate

3-6 Hours

 

 

BATTERY

PACK

Item No. 9

11378

 

 

(1323620)

 

 

FORWARD/REVERSE SELECTOR (DIRECTION OF ROTATION SELECTOR)

Your drill-driver has a forward/reverse selector located

above the switch trigger.

WRIST STRAP

A wrist strap is provided to reduce the chances of

dropping your drill-driver. Place one hand through the wrist strap when carrying tool.

BIT STORAGE

When not in use, bits provided with your drill-driver can be placed in the storage area located on the bottom of the motor housing.

LEVEL

To keep drill bit level during drilling operations, a level is located on the top and end of the motor housing.

dl_ WARNING: If any parts are missing, do not operate your drill-driver until the missing parts are replaced.

Failure to do so could result in possible serious personal injury.

7

Image 7
Contents OperatorsManual Page Model Battery Pack Charger Do not charge battery tool in a damp or wet loca Shock, fire and/or serious personal injury Symbol Name DESIGNATION/EXPLANATION DRILL-DRIVER SwitchSwitch Lock Battery PackBATTERYPAq Important Information for Recharging HOT Batteries Charging Battery PackTo Remove Battery Pack TWO Speedlo GEARTRAINHI-LOSPEED To Install Battery PackBattery Latches ReleasebatterypackForward Keyless ChuckSelectorwithrevers Centerlockposition Drillbit UnlockchuckRight To Adjust TorqueTo Decrease Torqueadjusting Ring Toincrease Drillbit Chuckjaws Lock ChuckScrewdriver BIT Drilling BIT StorageStoragearea Mallet Chuckjaws Chuck RemovalMallet To Retighten a Loose Chuck Batteries Battery Pack Removal and Preparation for RecyclingPage See Back page for Parts Ordering Instructions Parts ListMY-HOME